PSEG To Start Work In West Orange, Will Replace 3 Miles Of Gas Pipes

WEST ORANGE, NJ - The Public Service Electric & Gas Company (PSE&G) will be working in West Orange to replace about three miles of older gas pipes with new, durable plastic and/or coated steel piping, acording to a company news release.

“These upgrades are part of PSE&G’s three-year program to replace up to 510 miles of aging gas infrastructure throughout New Jersey,” said Joe Forline, vice president of gas operations for PSE&G. “We are working closely with municipal officials and the department of public works to coordinate construction schedules and are committed to keeping customers in West Orange informed about where and when the work will take place.”

According to PSE&G, the new pipes will "improve reliability, reduce the possibility of methane leaks, and enable the installation of excess flow valves on service lines."

PSE&G stated that the valves dramatically reduce gas flow if a pipe is damaged.

"The elevated pressure of the new gas mains will also provide better support for high-efficiency appliances like furnaces and water heaters," the utility provider added.

Work will begin on or about August 1, and will take place from Monday through Saturday between the hours of 8 a.m. and 5 p.m., conditions permitting, on the following streets:

PSE&G stated that residents will be notified when work begins in their area by phone, mail, email, door hangers and Facebook posts. The gas main replacement portion of the work is expected to be complete in October of 2016. The paving and street restoration is expected to be completed in November of 2016.

Customers can find more information at www.pseg.com/gaswork.

HOW WILL WORK BE DONE?
PSE&G stated that before construction can start, the utility plans to test soil and dig test holes to verify the location of existing gas mains. When this preliminary work is complete, PSE&G will begin installing the new gas mains and upgrading associated service lines that carry the gas to homes and businesses.

PSE&G provided the following information about the planned work:

• PSE&G crews will dig trenches, primarily in road surfaces, and lay new pipes block by block, in order to limit the impacted areas on any given day. There will be short-term road closures and detours during construction. Local police will direct vehicle and pedestrian traffic. At the end of each workday, the trenches will be filled in, and plates secured, on any open areas so people can safely drive and walk.
• After the new gas mains are installed, PSE&G will need to access customers’ homes to connect their service lines and meter. PSE&G will contact homeowners to arrange a date and time to do the connections. During the connection work, customers will be without gas service for approximately four hours. PSE&G will relight all appliances and make sure they are safely working before leaving a home.
• In most cases, PSE&G will be able to install the new pipes without digging in lawns. Lawn areas, shrubs or other vegetation affected by the work will be restored. Grass areas will be raked and seeded.
• PSE&G will repair roads with temporary pavement until the ground settles. This takes about 45 to 90 days, depending on the weather and soil conditions. PSE&G then restores the roads with permanent paving in accordance with town ordinance and paving requirements.
• PSE&G crews will use work area protection including traffic cones, utility work signs, and barriers to ensure the job is done safely. The utility reminds motorists to slow down and follow detour signs when driving through the construction area.

Send local news tips and photos to eric.kiefer@patch.com

Photo: PSE&G